Answer
Sep 02, 2025 - 01:25 PM
✅ 1. Does It Come with Batteries? Yes, it usually comes with a CR2016 or CR2025 battery pre-installed.
✅ 2. Do I Have to Program It to My Vehicle? Yes — this fob must be programmed to your vehicle in order to:
Lock/unlock the doors remotely (It’s separate from the ignition key — you don’t have to cut or clone anything if you're only using it for door locking.)🚗 Programming Steps:
1. Insert and remove the key in the ignition twice (do not turn it, just insert and remove).
2. Close and open the driver's door twice.
3. Insert and remove the key in the ignition once.
4. Close and open the driver's door twice again.
5. Insert the key, and leave it in the ignition.
6. Close the driver’s door.
7. Turn the key to “ON” (not start), then back to “OFF”:
8. Remove the key from the ignition.
9. The door locks should cycle automatically (lock then unlock) to confirm you’ve entered programming mode.
10. Press both LOCK and UNLOCK on the new fob for 1.5 seconds, then press LOCK alone for 1 second.
11. The door locks will cycle again to confirm the new fob was added.
🛑 If the locks do not cycle at any step, it means the programming failed. Repeat the steps carefully.
✅ 2. Do I Have to Program It to My Vehicle? Yes — this fob must be programmed to your vehicle in order to:
Lock/unlock the doors remotely (It’s separate from the ignition key — you don’t have to cut or clone anything if you're only using it for door locking.)🚗 Programming Steps:
1. Insert and remove the key in the ignition twice (do not turn it, just insert and remove).
2. Close and open the driver's door twice.
3. Insert and remove the key in the ignition once.
4. Close and open the driver's door twice again.
5. Insert the key, and leave it in the ignition.
6. Close the driver’s door.
7. Turn the key to “ON” (not start), then back to “OFF”:
- Do this once to add a new remote, or
- Do this twice to erase all existing remotes and add a new one.
8. Remove the key from the ignition.
9. The door locks should cycle automatically (lock then unlock) to confirm you’ve entered programming mode.
10. Press both LOCK and UNLOCK on the new fob for 1.5 seconds, then press LOCK alone for 1 second.
11. The door locks will cycle again to confirm the new fob was added.
🛑 If the locks do not cycle at any step, it means the programming failed. Repeat the steps carefully.
