Answer
Jun 26, 2024 - 02:00 PM
Good afternoon
2002 Toyota Sequoia Keyless Entry Remote Fob Programming Instructions
2002 Toyota Sequoia Keyless Entry Remote Fob Programming Instructions
Have all transmitters for the vehicle at hand
- With the key out of the ignition, unlock and open drivers door (all other doors must be closed)
- Within 5 seconds, Insert the key into the ignition (Do NOT Turn it) and Pull key out.
- Within 40 seconds, Close then open the drivers door.
- Insert the key into the ignition (Do NOT Turn it) and Pull key out.
- Close then open the drivers door.
- Within 40 seconds. Close then open the drivers door.
- Insert the key into the ignition (Do NOT Turn it) and Pull key out.
- Close then open the drivers door.
- Insert the key into ignition and leave it in the ignition.
- Close the drivers door. Turn the ignition to ON then back to OFF (Do NOT Start or crank engine).
- Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode. Return to step 1 if the door locks do not cycle at this point or try the alternate procedure listed below.
- Within 40 second, A. Press the lock and unlock buttons on the remote simultaneously for 1.5 seconds.
- Remove the key from the ignition.
- B. Immediately after letting go of the lock and unlock buttons, press and hold the lock button by itself.
- Within 10 seconds, the door locks should lock and then unlock once indicating successful programming.
- (If the door locks cycle twice, repeat steps A and B in step 6 as the remote was not accepted)
- Repeat steps A and B in step 6 for each new remote.
- Open drivers door.
Alternate programming procedure: Have all remotes for the vehicle ready. Toyota Sequoia vehicles use step 10a, all other vehicles use 10b.
- Make sure all doors are closed
- Open Driver’s door
- Insert key into ignition, then remove it
- Press LOCK and UNLOCK on the vehicle door lock switch at 1 second intervals 5 times.
- Close and re-open driver’s door
- Press LOCK and UNLOCK on the vehicle door lock switch at 1 second intervals 5 times.
- Insert key into ignition switch
- Turn the ignition to ON then back to OFF (Do NOT Start or crank engine).
- Remove Key from ignition
- Door locks should cycle to confirm entry into programming mode a a. AVALON – Press LOCK on remote for a minimum of 1 second
- b. ALL OTHER VEHICLES – Press and hold LOCK & UNLOCK together for 1.5 seconds; then press and hold LOCK until the locks cycle
- Locks should cycle once to confirm programming. If they cycle twice, the programming failed
- Repeat button procedure to program remaining remotes
- Close driver’s door. Test remotes.
2002 Toyota Sequoia Key Programming Instructions
Have your master Toyota key at hand (black key)
- Insert black programmed key into ignition.
- Press and release accelerator pedal 5 times within 15 seconds of inserting key into ignition.
- Press and release brake pedal 6 times within 20 seconds of step 2.
- Remove black key from ignition switch.
- Insert new unprogrammed key into ignition within 10 seconds of step 4.
- Press and release accelerator pedal once within 10 seconds of step 5.
- Once these steps are performed properly you will see the immobilizer warning lamp begin to flash and after one minute the lamp will stop flashing. Once the immobilizer warning lamp stops flashing you will have ten seconds to insert an additional key to be programmed.
- Within ten seconds of inserting key into ignition press and release accelerator pedal once.
- Immobilizer warning lamp will flash and after one minute the lamp will shut off.
